Gym Equipment Maintenance guidelines
Posted: August 20th, 2020, 1:22 pm
Equipment Maintenance guidelines
Each preventative maintenance visit must include the following:
1) For all equipment types:
a. Inspection of the unit, repairs, adjustments, lubrication
b. Check all nuts, bolts and other fasteners; tighten where required
c. Check all bushings, fittings and weldments
d. Check all wires, cables and contact points
e. Check all seats and pads for wear. If worn out or ripped, replace
2) For all treadmills:
a. Inspect motor compartment
b. Check D.C. motor brushes
c. Check drive belt(s)
d. Check front and rear rollers
e. Check running belt and deck
f. Lubricate deck surface in accordance with manufacturer’s specifications.
g. Check and calibrate, if necessary, elevation components
3) For all universal type and single station weight machines:
a. Inspect clean and lubricate chains and guide rods
b. Inspect cables, weight plates and pads
4) For all upper body cycles:
a. Inspect primary and secondary drives, tension assembly and electronic components b. Inspect, clean and lubricate chains
5) For all stair simulators:
a. Check belts resistance and electronic components
b. Clean and lubricate chain fittings
6) For all ski simulators:
a. Inspect, adjust and lubricate rails, rollers and bearings
b. Inspect tension controls c. Check display, if any
7) For all bikes:
a. Inspect primary chains or belts, friction belt, electronic and control boards, flywheel, primary and secondary drives
Each preventative maintenance visit must include the following:
1) For all equipment types:
a. Inspection of the unit, repairs, adjustments, lubrication
b. Check all nuts, bolts and other fasteners; tighten where required
c. Check all bushings, fittings and weldments
d. Check all wires, cables and contact points
e. Check all seats and pads for wear. If worn out or ripped, replace
2) For all treadmills:
a. Inspect motor compartment
b. Check D.C. motor brushes
c. Check drive belt(s)
d. Check front and rear rollers
e. Check running belt and deck
f. Lubricate deck surface in accordance with manufacturer’s specifications.
g. Check and calibrate, if necessary, elevation components
3) For all universal type and single station weight machines:
a. Inspect clean and lubricate chains and guide rods
b. Inspect cables, weight plates and pads
4) For all upper body cycles:
a. Inspect primary and secondary drives, tension assembly and electronic components b. Inspect, clean and lubricate chains
5) For all stair simulators:
a. Check belts resistance and electronic components
b. Clean and lubricate chain fittings
6) For all ski simulators:
a. Inspect, adjust and lubricate rails, rollers and bearings
b. Inspect tension controls c. Check display, if any
7) For all bikes:
a. Inspect primary chains or belts, friction belt, electronic and control boards, flywheel, primary and secondary drives